Controlled-products-systems-group 1504-080 Uživatelský manuál Strana 1

Models 1506 and 1504 Programmable Stand Alone Digital Keypad Entry Devices DoorKing, Inc.120 Glasgow AvenueInglewood, California 90301 U.S.A. Pho

1.3 Wiring Diagram 6 234512 11 110 9 8 714 13GNDMasterCodeONOFFElectric StrikeMagnetic LockPower16 VAC, 20 VAKeypad PowerPushto ExitTimeZone 2TimeZone

1.4 Circuit Board Terminal Identification 1. REQUEST TO EXIT – A switch closure to terminal 12 will activate relay 1 for its programmed strike time

1.5 Model 1504 Aiphone Intercom Station Connections These wire diagrams are provided for convenience only. For detailed wiring information on Aiphon

1.6 Secondary Keypad Wiring 1599-010 Board1506-081 Secondary KeypadTo Main Terminals13 and 14To Secondary Keypad Light8-Conductor22 AWGShielded Cable

Page 14 1506-065-D-1-09

SECTION 2 - PROGRAMMING Keep a record of the programmed codes by completing the tables on pages 24 and 25. 2.1 Master Code The Master Code is a four

2.4 Programming Four-digit Entry Codes 1. Press *02 and enter the four-digit master code _ _ _ _ (short beep). 2. Enter the four-digit code _ _ _

2.8 Programming Five-digit Entry Codes 1. Press *09 and enter the four-digit master code _ _ _ _ (short beep). 2. Enter the five-digit code _ _ _ _

2.12 Hold Boundary Programming The entry system hold boundaries establish a set of four-digit entry codes that will latch relay 1 ON, relay 2 ON, or

SECTION 3 – OPERATING INSTRUCTIONS 3.1 Four-digit Entry Codes To use a four-digit entry code, the # key must first be pressed then the four-digit cod

Page 2 1506-065-D-1-09

3.5 Hold Feature Operation The relay hold feature allows a set of four-digit entry codes to latch (or hold) a relay indefinitely. Any four-digit entr

3.6 Time Zone Operation The entry system has two time zone inputs. By using an external timer or switch, access can be denied to a group of four-digi

Page 22 1506-065-D-1-09

SECTION 4 - APPENDIX 4.1 Troubleshooting • Have a good VOM meter to use when checking voltages and continuity. • Check power wiring wire size and d

4.2 Data Tables Use the tables below to record data entered into the keypad system. MASTER CODE 4-DIGIT HOLD BOUNDARIES LOWER UPPER 4-DI

NAME 4-DIGIT CODE NAME 4-DIGIT CODE

Use this manual with the following models 1506-080, 1506-081, 1506-082, 1506-083, 1506-084, 1506-085, 1506-086, 1506-090, 1506-091, 1506-092, 1506-09

Page 4 1506-065-D-1-09

Table of Contents IMPORTANT NOTICES...

2.15 IMPORTANT NOTICES • Prior to starting the installation, become familiar with the instructions, illustrations and wiring diagrams in this manu

SECTION 1 - INSTALLATION 1.1 Mounting Surface mount units can be mounted directly to a wall or pilaster, or they can be mounted using a gooseneck mou

The flush mount keypad consists of two parts, the keypad and the rough-in box. Mount the rough-in box and wiring first, and then install the keypad i

1.2 Wiring The wiring of this device is an extremely important and integral part of the access control system. It is very important that proper wire