Controlled-products-systems-group 8550C-7 Uživatelský manuál stáhnout pdf (Strana 10)

5 Hang the garage door opener

To avoid possible SERIOUS INJURY froma falling

garage door opener,fasten it SECURELY to

structural supports ofthe garage. Concrete anchors

MUST be used if installing ANY brackets into

masonry.

HARDWARE

Hex Bolt 5/16"- 18x7/8"

Nut 5/16"-18

Lock Washer

5/16"

Installation

Hanging your garage door opener will varydepending on your

garage. Two representative installations are shown.Yours may

be different.Hanging brackets should be angled (Figure 1) to

provide rigid support.On finished ceilings (Figure 2),attach a

sturdy metal bracketto structural supports before installing the

opener. This bracket and fastening hardware are notprovided.

Instructions below are for attaching the garage door opener

directlyto structural supports.

5.1 Measure the distance from each side ofthe motor unit to

the structural support.

5.2 Cutboth pieces ofthe hanging bracket to required lengths.

5.3 Drill 3/16" pilot holesin the structural supports.

5.4 Attach one end of each bracket to a support with 5/16"-

18x1-7/8" lag screws (notprovided).

5.5 Fasten the opener to the hanging bracketswith 5/16"-

18x7/8" hex bolts,lock washers and nuts.

5.6 Checkto make sure the rail iscentered over the door (or in

line with the header bracket if the bracket is not centered

above the door).

5.7 Remove the 2x4.Operate the door manually. Ifthe door

hitsthe rail,raise the header bracket.

NOTE: DO NOT connect power to opener at this time.

FIGURE 1

FIGURE 2

(Not Provided)

Lag Screws

5/16"- 18x1-7/8"

Measure

Distance

Hex Bolt 5/16"- 18x7/8", Lock Washer 5/16", Nut 5/16"-18

FIGURE 3

Not Provided

Finished Ceiling

Unfinished Ceiling

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 81 82

Komentáře k této Příručce

Žádné komentáře

Controlled-products-systems-group 8550C-7 Uživatelský manuál Strana 10

Komentáře k této Příručce

Související produkty a manuály pro Senzory Controlled-products-systems-group 8550C-7